C++ infrared programming

Description:
When multiple infrared switch trigger signal is sent to computer after,
How to use the c++ program to distinguish the current trigger the switch?

What need infrared switch and used to develop the c/c++ development kit?

Whether the software and hardware needed to support?

Thank you master pointing

If you can give specific code with good
I was the first development
Please enlighten

Started by Connie at November 09, 2016 - 4:24 AM

What do you like for the interface?
The board?
Serial port?
U port? You must plan... Good physics to do
Usually, the simplest way is to use single chip computer, the process of signal detection, and then to the computer through the serial port to send

Posted by Orville at November 14, 2016 - 4:48 AM

Need to allocate an interrupt and I/O address of each switch

Posted by Kerwin at November 24, 2016 - 5:04 AM

Posted by Orville at November 29, 2016 - 5:50 AM

Thank you for your reply.

I want to do a single receiving, encoding, decoding the signal of infrared emitter.

What hardware specific needs, how to configure

Thank you

Posted by Connie at December 14, 2016 - 6:23 AM