How to enable.NET Fusion Log

Recommended for you: Get network issues from WhatsUp Gold. Not end users.

Fusion log is mainly used for tracking the assembly load information. For example, a direct reference to the third party programs set A on another assembly B, but B does not reference. This opens the Fusion log it is easy to check the cause.

Here is found a couple of Fusion Log introduced on the Internet, say good:

  1. Fusion Log Could not load file in diagnosis of " or assembly" problems
  2. Debugging load problems using fusion log

If Fusion is not enabled on Log, into the following registry file, and then restart IIS, you can enable Fusion Log.

Windows Registry Editor Version 5.00


Fusion Log can be displayed in the error page (see screenshot below).




You can also view the Fuslogvw.exe tools, the following is a MSDN on the tool introduction. The use of time attention, under Windows 7 need administrator privileges to run, otherwise open the program cannot do any operation.

  1. MSDN - Assembly Binding Log Viewer (Fuslogvw.exe)


Recommended from our users: Dynamic Network Monitoring from WhatsUp Gold from IPSwitch. Free Download

Posted by Kelly at November 14, 2013 - 9:06 AM